Manifold for BMW M50 / M52 / M54
Included:
Manifold
Nozzle Bridge (Found M20x1.5)
80mm. throttle
Thread type for studs for manifold pressure, etc. is M12x1.5
This manifold needs some modification / customization. These are modifications that can easily be made by the man himself.
- Flange -> Intake Pipe - Here, with a hand grinder, the edge between the flange and the intake tube must be adjusted for perfect flow. Expect 30 min machining time
- Depending on which nozzles you choose to drive with, 2 pieces must be made. spacers of about 7-8mm. This can be done with a tube that is 8mm inside. (since bolt fitting for nozzle bridge is 8mm.) Expect 15 min working time
- The manifold is fitted with an 80mm. universal throttle, for this a small plate must be made between bolt fitting of the throttle sensor and throttle. Expect 30 min working time.
- On the underside of the manifold there is a bolt flange (76mm. Center bolt holes) where a flange can be mounted where one can mount a nipple for mounting idle motor. "Block off to 38mm. Wastegate" can be used here.